Product Introduction; Technical Parameters - Swann CURING LIGHT Instruction Manual

Turn on/off
Authorised Representative in the
EUROPEAN COMMUNITY

1 Product introduction

The curing light manufactured by Guilin Refine Medical Instrument Co., Ltd. uses the principle of light radiation
to irradiate photosensitive resin in order to quickly cure it. This product is intended for use in hospitals and dental
clinics and it's used for prevention and treatment of dental complications of adults or children.
Scope of application: suitable for dentistry, used to cure light-curing materials.
Product composition: main unit, LED light, light hood, charging base, battery and power adapter, etc.
The features of this product are:
1.1 A variety of different working modes and working hours can be set.
1.2 Constant light power output, the decrease of battery power will not affect the curing effect.
1. 3 Large-capacity battery. While full charged, under 10 seconds of light per time, it can be used continuously for
more than 500 times.
1. 4 Product schematic
Screen of base
2 Replacement instructions for accessories
Accessories Period of replacement
Power adapter Damaged
Charging base Damaged
Battery Damaged
Light hood Damaged

3 Technical parameters

3.1 Technical Parameters of each model (table 1)
Dimensions
Net weight
Classified by power supply
Input
Rechargeable lithium battery
Power supply (Adapter)
Performance of led lamp
Light Intensity
Inspection method of LED
lamp
Light guide
light hood
on/off
Screen
Time/mode
Light meter
Method of replacement
Replace directly according to the requirements of the manual.
Replace directly according to the requirements of the manual.
Take out the damaged battery and replace it with a new one.
Replace directly according to the requirements of the manual.
Φ86mm*223mm
265g
Powered by rechargeable lithium battery
Charging: DC5V 1A
Battery model: ICR 18650
Battery voltage and capacity: 3.6V/2600mAh
The battery has overvoltage, overcurrent and short circuit protection.
Input : 100-240V AC 50Hz/60Hz 0.4A Max Output: DC 5V/1A
Built-in fuse: T1A 250V
a) 10W high power blue and purple LED lamp.
b) Wave length: 385nm-515nm
c) Category: class I.d)Shoot limit(AEL): 3.9*10―³J
1000mW/cm²-2500mW/cm²
When operating correctly, the LED lamp lights up, indicating that the lamp is in
good condition. Dental resin materials commonly used in clinic can match the
wavelength of this curing light, such as 3M, Dentsply and other resins.
M
Mode
T
Time setting
Power connector
Working: 3.6V lithium battery(ICR 18650)
3