Advertisement
Installation
ENGINE INSTALLATION
1. ENGINE MOUNT BOLT,
244-298 NM (182-220 LB-FT)
2. WASHER
STEP 42
If engine rubber isolators require replacement,
remove and discard isolators (3 and 4). Install new
rubber isolator (4), then rubber isolator (3).
9
3. INSOLATOR UPPER
4. INSOLATOR LOWER
6
5
7
5. WASHER
7. NUT
6. WASHER
8. REMOTE OIL DRAIN HOSE
STEP 43
Slowly raise engine and move into position over rear
chassis. Be sure all harness connections and hoses
are out of the way then lower engine. Put washer (5)
between front rubber isolator (4) and chassis. Install
washer (2), bolt (1), washer (6), and nut (7) in engine
isolators. Lower engine into position.
1
2
3
4
9. OIL FILL TUBE
2000-11
W110R468
Advertisement
