Protecting The Environment; Specifications; Maintenance - Black & Decker LD116 Instruction Manual

f Minimize stalling on breakthrough by reducing pressure
and slowly drilling through the last part of the hole
f Keep the motor running while pulling the bit out of a
drilled hole. This will help reduce jamming.
f Make sure switch turns drill on and off.
Drilling in wood
Holes in wood can be made with the same twist drill bits
used for metal or with spade bits. These bits should be
sharp and should be pulled out frequently when drilling to
clear chips from the flutes.
Drilling in metal
Use a cutting lubricant when drilling metals. The
exceptions are cast iron and brass which should be drilled
dry. The cutting lubricants that work best are sulfurized
cutting oil or lard oil.
Drilling in masonry
Use carbide tipped masonry bits. Refer to Drilling section.
Keep even force on the drill but not so much that you crack
the brittle material. A smooth, even flow of dust indicates
the proper drilling rate.

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of
the tool into a liquid.
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste. Should
you find one day that your BLACK+DECKER
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.

SPECIFICATIONS

Voltage
No-Load speed
Chuck
Torque
BATTERY
Voltage
Battery type
CHARGER
Input
Output
Charging time
* Maximum initial battery pack voltage (Measured
without a workload) is 16 volts. Measured under
a workload, nominal voltage is 14.4.
ENGLISH • 23
LD116
16V MAX*
0 - 650/min (rpm)
3/8" (10mm)
110 in-lbs (12,4Nm)
LD116BAT
16V MAX*
Ion Litio
100-240V ~ 50-60Hz 300mA
8-20V 400mA
3-5 hours