Part Names; Wired Remote Controller - Toshiba RAV-RM401MUT-E Owner's Manual

2

Part Names

 Indoor unit
93-EN
– 47 –
3
• For using the wired remote controller RBC-AMS55E* or the wireless remote controller RBC-AX32UM*, refer to the Owner's
Manual attached to the above remote controllers.
This remote controller can control the operation of up to 8 indoor units.
Horizontal louver / Vertical
 Display section
grille / Air discharge
The air discharge direction can be
changed.
In the display illustration below all the icons are shown. When the unit is in operation,
only relevant icons will be displayed.
• When the leak breaker is turned on for the first time,
Earth screw
part of the remote controller.
Inside the electrical box.
• While this icon is flashing, the model is being automatically confirmed.
Wait till
Air intake grille
Air is taken in through here.
Air filter
Filters out dust.
(Behind the air intake grille)
1
2
3
4
5
6
7

Wired remote controller

icon has disappeared to use the remote controller.
7 8
3 4
1
2
5
6
9
18
10
20
21
Operation mode
The selected operation mode is displayed.
Check display
Displayed while the protective device works or a
problem occurs.
SETTING display
Displayed during setup of the timer or other settings.
TEST run display
Displayed during a test run.
Timer display
Indicates time concerning the timer.
(Indicates a check code when a problem occurs)
Timer mode display
The selected timer mode is displayed.
Louver position display
Displays louver position.
Display
flashes on the display
section
TEMP. ON / OFF
Operation
TIMER SET FAN MODE
section
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
14 13
12
11
15
19
16
17
8
Swing display
Displayed during up / down movement of the louver.
9
Filter display
Reminder to clean the air filter.
10
Fan speed display
The selected fan speed mode is displayed.
(Auto)
(High)
(Med.)
(Low)
11
Set temperature display
The selected set temperature is displayed.
12
Power saving mode display
Limits compressor speed (capacity) to save energy.
94-EN