Valcom VIP-422A Quick Start Manual

LAY-IN TALKBACK IP CEILING SPEAKER
INTRODUCTION
The VIP-422A Lay-In Talkback IP Ceiling Speaker
enable voice access to a single zone of paging over
an IP-based network. This allows a page zone
extension anywhere on the network. The speaker
output level is electrically adjusted during setup.
The lay-in ceiling speaker grille is made of steel
with a white baked enamel finish. The VIP-422A
replaces a 2' x 2' ceiling tile. Power is provided to
the unit via a Power over an Ethernet (PoE) switch
meeting the 802.3af specification.
SPECIFICATIONS
Access Methods

PBX, FXO Port w/VIP-811

POTS telephone set w/VIP-811

PBX, FXS Port w/VIP-821

Valcom M Cast Page Group

SIP – enabled telephone system
Features

RJ-45 network connection

Power over Ethernet (PoE) 802.3af compliant

High Efficiency Class-D Amplifier

Environment
Temperature:
Humidity: 0 to 85% non-precipitating
Packing List
Qty.
1 Lay-in Ceiling Speaker
1 VSP Document
VIP-422A
0 to +40° C
Item
INSTALLATION
Dimensions/Weight
VIP-422A:

23.75" L x 23.75" W x 3.75" D
(60.33cm) x (60.33cm) x(9.53cm)

Weight: 5.5 lbs. (2.49kg)
FCC Information
This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates uses,
and can radiate radio frequency energy and if
not installed and used in accordance with the
instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area
may cause harmful interference in which case
the user will be required to correct the
interference at his own expense.
1
Issue 1
947764