Hitachi BD-W85SV Operating & Installation Instructions Manual page 24

How to Install the Washing Machine
Conecting the
water supply
24
3WPL083821
●
Water supply hose
■
Optimum water pressure is 0.03-0.8MPa.
■
Do not connect to the mixer tap of an unpressurised hot-water
apparatus.
■
Use a horizontal tap.
Horizontal tap
Connect the water supply hose to the rear panel of
the washing machine.
Make sure that the rubber seal is inside the hose
connector.
* Model with SCREW TYPE water supply hose.
Firmly connect the water supply hose to the tap, and
check connection points for water-tightness.
* Model with ONE TOUCH JOINT water supply hose.
1. Untighten the upper connector
screw.
Upper connector Rubber packing
Fixing screw
●
In case the diameter of the tap
is large, remove the guide plate.
Guide plate
Connector
3. Connect the water supply
hose to the middle connector,
pushing the plate down.
Middle connector
Water supply hose
Extension tap
Hose connector
2. Push the upper connector up
till the rubber packing is in
tight contact with the tap. Then
tighten the 4 screws.
Rubber packing
Middle
connector
Upper connector
Middle connector
●
Turn the middle connector so
that there is no water leak.
●
To separate the water supply
hose from the middle connector,
turn off the tap, and then pull
the inlet hose down, pushing
the plate down.
Square tap
Rubber seal