Hitachi BD-W85SV Operating & Installation Instructions Manual page 20

Problem
●
Foam remains You may have used too much detergent.
●
on the door or Laundry is new or not that soiled.
the door seal.
●
Fabric softener You may have exceeded the max. level of
overfl ows. softener in the detergent dispenser
●
Fabric softener The softener cover may have come out.
remains.
●
There's You may have used too much detergent.
detergent
●
powder residue You may have poured detergent in the
in the detergent detergent dispenser when it was wet. Wipe
dispenser. the water away before adding detergent.
●
The washing There may be noise from other electrical
machine appliances nearby such as a TV, a radio,
switches off etc.
during operation.
●
The motor may be locked due to overload,
the clothes being trapped in the rubber seal,
etc.
●
Odor in the Rubber parts may give off a smell when you
washing fi rst start using the washing machine.
●
machine There may be mold, dirt or detergent
residue on the drum.
●
Unsatisfactory You may have used too little detergent.
washing results
●
You may have poured detergent directly into
the drum.
●
Unusual noise or The transport bolts may not have been
vibration removed.
●
The washing machine may be installed on a
sloping or unstable surface.
●
There may be foreign objects inside the
drum.
●
Noise during This is normal. There may be noise when
drain cycle the drain pump is on.
●
There's the This is normal. Liquid is inside the 4-Ply
sound of water Liquid Load Balancer fi xed onto the drum to
when the drum is make it balanced.
rotated manually.
●
Tapping noise This is normal. Tapping sound is generated
comes out at when laundry touches to the laundry
spin start. protection bulge on the laundry inlet.
●
Detergent In some environmental or usage conditions,
dispenser is wet. Detergent dispenser may get wet due to
condensation.
20
3WPL083821
Troubleshooting
Possible Cause Solution
●
Use the appropriate amount of
detergent.
●
Do not pour in more than the
. max. level of softener.
●
Firmly set the softener cover
on the detergent dispenser.
●
Use the appropriate amount of
detergent.
●
Wipe the water away before
adding detergent.
●
Unplug the power cord and
plug in again. Then select
a program and start. Do not
place electrical appliances
close to the washing machine.
●
This is not a malfunction. Wait
for about one hour and restart
the program.
●
The smell goes away over
time.
●
Run the Tub Clean program.
●
Use the appropriate amount of
detergent.
●
Pour detergent in the
appropriate dispenser.
●
Remove the transport bolts
before using.
●
Install the washing machine on
a horizontal, stable surface.
●
Remove foreign objects such as
coins, pins, etc. from the drum.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.
●
This is not a malfunction.