Advertisement
Available languages
Available languages
Installation Instructions
Bag Adjustment
When handle height is changed bag adjustment may
be required. A properly adjusted bag should be taut
on top cloth area between front bag handle and rear
bag hanger handles. If bag is too tight or too loose,
adjust as follows:
1.
Stop engine and disconnect spark plug wire.
2.
Remove bag from rear bag hanger. Remove
bolt(s) and knob(s) securing hanger clamps to
handle sections (Fig. 9). Hanger clamps have
four adjustment holes.
4
2
3
Figure 9
1. Knob
2. Bolt
3.
Reassemble hanger clamps to handle sections
using whichever set of holes best holds bag taut.
Using lower holes in hanger clamps tightens bag
assembly and upper holes in hanger clamps
loosens bag assembly.
Note:
Under normal use, bag materials are
subject to deterioration and wear.
Check grass bag often and replace
when necessary with an original
equipment replacement bag. A
weakened or inferior bag may let
objects pass through, causing injury.
EN-4
1
1011
3. Hanger clamp
4. Bag hanger
POTENTIAL HAZARD
Keep hands, sticks or other objects out of
grass chute while blade is turning.
WHAT CAN HAPPEN
Thrown objects or blade contact can cause
serious injury.
HOW TO AVOID THE HAZARD
Always stop engine when emptying grass
bag and disconnect spark plug wire before
cleaning a clogged chute, bag tunnel or
underside of mower housing.
4.
Reconnect spark plug wire.
Advertisement
