Advertisement
Available languages
Available languages
7.
Two shoulder bolts on the mower housing
protrude through slotted holes in the chute
assembly and do not have to be loosened or
removed. Chute assembly moves over the
shoulder bolts (Fig. 5).
8.
Slide chute assembly in a clockwise direction to
install or counterclockwise to remove.
9.
Secure with screw (Fig. 5).
10. To ensure the chute was installed properly, rotate
blade a few revolutions by pulling slowly on
starter cord or look under deck to see if blade
contacts chute baffle.
POTENTIAL HAZARD
A non-Toro replacement cutting blade
could strike chute baffle when engine is
started and run.
WHAT CAN HAPPEN
Blade contact with chute baffle will cause
damage which could result in an unsafe
operating condition or thrown objects.
HOW TO AVOID THE HAZARD
Use only Toro original equipment or Toro
replacement cutting blade.
11. Remove knob and bolt securing left side upper
and lower handle sections (Fig. 6).
4
2
3
Figure 6
1. Knob
2. Bolt
1011
1
3. Hanger clamp
4. Bag hanger
12. Hold hanger clamp on outside of handle
sections. Insert handle bolt from inside of handle
sections through holes in hanger clamp.
13. Position bag hanger leg into hanger clamp
groove and secure with knob. Repeat steps and
assemble clamp and hanger to right side handle
sections.
14. Close rear of bag by folding sides in and
pressing interlocking rear handle halves together
(Fig. 7).
Figure 7
15. Position rear bag handles into bag hanger on
handle.
16. Grasp bag assembly handle and slide over flange
of grass chute (Fig. 8). Push downward on
handle until it seats into position.
Figure 8
17. Reconnect spark plug wire.
Installation Instructions
1012
1010
EN-3
Advertisement
