Hints And Tips - Zanussi ZDI22001XA User Manual

Hide thumbs Also See for ZDI22001XA:
Table of Contents

Advertisement

Available languages

Available languages

AT THE END OF THE PROGRAMME
The indicator
comes on. If you do not deactivate the appliance within 5 minutes all indicators goes off.
This helps to decrease energy consumption.
Turn the knob to
. Close the tap.

HINTS AND TIPS

GENERAL
The following hints will ensure optimal cleaning and
drying results in daily use and also help to protect
the environment.
Remove larger residues of food from the dishes
into the waste bin.
Do not pre-rinse dishes by hand. When needed,
use the prewash programme (if available) or
select a programme with a prewash phase.
Always use the whole space of the baskets.
When loading the appliance, make sure that the
dishes can be completely reached and washed
by the water released from the spray arm
nozzles. Make sure that items do not touch or
cover each other.
You can use dishwasher detergent, rinse aid
and salt separately or you can use the multi-
tablets (e.g. ''3in1'', ''4in1'', ''All in 1''). Follow the
instructions written on the packaging.
Select the programme according to the type of
load and degree of soil. With the ECO
programme you have the most efficient use of
water and energy consumption for crockery and
cutlery with normal soil.
5 min
THE WATER SOFTENER
The water softener removes minerals from the
water supply, which would have a detrimental effect
on the washing results and on the appliance.
The higher the content of these minerals, the harder
your water is. Water hardness is measured in
equivalent scales.
The water softener should be adjusted according to
the hardness of the water in your area. Your local
water authority can advise you on the hardness of
the water in your area. It is important to set the right
level of the water softener to assure good washing
results.
USING SALT, RINSE AID AND DETERGENT
Only use salt, rinse aid and detergent for
dishwasher. Other products can cause damage
to the appliance.
Multi-tablets are usually suitable in areas with a
water hardness up to 21 °dH. In areas
exceeding this limit, rinse aid and salt must be
used in addition to the multi-tablets. However, in
areas with hard and very hard water we
recommend to use solo-detergent (powder, gel,
tablets without additional functions), rinse aid
and salt separately for optimal cleaning and
drying results.
11

Advertisement

Table of Contents
loading

Table of Contents