Table of Contents
Advertisement
The sliding/tilting roof is operated by means of the control dial
fig. 32
and only functions when the ignition is switched on. The control dial
has a number of fixed positions.
After switching the ignition off, it is still possible to open or close the
windows for a further 10 minutes. It is no longer possible to operate the
sliding/tilting roof after opening or closing one of the front doors, however.
Note
•
It is possible that the sliding/tilting roof does not close fully after the car
battery has been disconnected and reconnected. Here you have to press
the control dial forward to switch position
•
It is necessary after each emergency operation (using crank handle)
to move the sliding/tilting roof into the basic position. Here you have to
press the control dial forward to switch position
seconds.
Opening and tilting
Comfort position
– Turn the switch to position
Opening roof fully
– Turn the switch to position
(spring-tensioned position).
Tilting roof
– Turn the switch to position
The wind noise in the comfort position is less than when the roof is fully
opened.
Using the system
Safety
⇒ page 52,
A
for about 10 seconds.
A
A
for about 10
A
A
⇒ page 52, fig.
32.
C
A
and hold it in this position
B
A
.
D
Driving Tips
The sun screen is also opened automatically when the roof slides open.
You can slide the sun screen into the opened or closed position by hand
when the sliding/tilting roof is closed. (This does not apply for models fitted
with sliding/tilting roof with solar cells, in which the sun screen is a fixed
element.)
Caution
It may be necessary during winter to remove any ice and snow in the area
of the sliding/tilting roof before opening it in order to prevent damaging the
opening mechanism.
Closing
Sliding closed/closing the sliding/tilting roof
– Turn the switch to position
Safety closing
The sliding/tilting roof is equipped with an overload protection system. The
sliding/tilting roof stops and moves back several centimetres when it
cannot be closed because there is something in the way (e.g. ice). You
can close the sliding/tilting roof completely without overload protection by
A
pressing the switch to the
position
A
long as it takes for the sliding/tilting roof to shut completely ⇒
WARNING
Close the sliding/tilting roof carefully - risk of injury!
General Maintenance
Breakdown assistance
Unlocking and locking
A
⇒ page 52, fig.
32.
A
⇒ page 52, fig. 32
at the front for as
.
Technical Data
53
Advertisement
Table of Contents
