Table of Contents
Advertisement
MODE 1: UPRIGHT VAC
Fig. 7
Fig. 8
TO ASSEMBLE:
1 Place the floor nozzle on a level surface.
2 Align the tube on the canister with
the tube on the nozzle. Lower canister
onto nozzle until it clicks into place.
(Fig. 7)
When attaching the motorized floor
nozzle, ensure that the latching
mechanism is fully locked in place
to ensure electrical connection has
been made.
3 Attach the end of the extension
wand to the tube on the back of the
Lift-Away canister until it clicks
into place. (Fig. 8)
8
1-800-798-7398
b
Upper Cord
Storage
Wrap
c
Fig. 9
4 Slide the accessory holder (a)
positioned opposite the upper cord
wrap, over the extension wand.
Align the tab with the groove and
push down. (Fig. 9)
5 Push the handle (b) onto the top of
the extension wand until it clicks
into place. (Fig. 9)
6 Insert the end of the stretch hose (c)
into the connector on the back of the
canister, pressing it in until it clicks
into place. (Fig. 9)
7 Store the dusting brush (d) and the
crevice tool (e) on the mounts of
the accessory holder. (Fig. 9)
Suction
Release Collar
c
Rotate
d
counterclockwise
to reduce suction
for easier push
a
and pull on high
pile carpets and
area rugs.
e
TO USE:
1
Rotate the cord release to quickly
release the power cord.
2 Secure the power cord in the
cord hook.
= Brushroll ON
= Bare Floor
= OFF
3 Press the On/Off switch (a) to the
"I" position to vacuum bare floors
(straight suction only) or to
the "II" position to engage the
motorized brushroll (for vacuuming
carpets and rugs). (Fig. 10)
IMPORTANT: The brushroll indicator
light (b) will illuminate green when the
brushroll is on, or red if there is a blockage
or jam. (Fig. 10) This feature is designed
to protect your Lifetime Belt that powers
your brushroll See Checking for Blockages
section for more information.
a
b
Fig. 11
Fig. 10
4 To activate the brushroll, place your
foot on the floor nozzle and recline
the handle. (Fig. 11)
NOTE: The brushroll will not spin
unless the nozzle is flat against the
floor and the handle is tilted back.
5 Due to the huge suction power
of this vacuum, it may become
necessary at times to adjust
the suction release collar (c)
on the handle. (Fig. 10) If the
vacuum seems difficult to push
or pull, or if it is lifting area rugs,
rotate the suction release collar
counterclockwise to reduce suction.
Rotate the collar clockwise to
increase suction.
6 Empty dust cup after vacuuming
and periodically during use when it
appears full. See Maintenance section
for instructions.
7 When you are finished vacuuming,
turn the vacuum off.
sharkclean.com
9
Advertisement
Table of Contents
