Table of Contents
Advertisement
Malfunction
Washing water is not
pumped out.
No water flows into
the device. The
detergent was not
washed in.
Start several times
with centrifugation.
The program duration
changes during the
wash cycle.
Cause and Troubleshooting
Immediate measure: mix a tablespoon of fabric softener
▶
ter with 0.5 l of water and pour this mixture into
the manual dosing compartment (not for outdoor,
sportswear and down textiles).
When the intelligent dosing is activated, re-
▶
then induce the basic dosing amount
→ Page 42 .
When dosing manually, reduce to the full
▶
next wash with the same load the amount of
detergent.
Unauthorized extension mounted on the water drain
hose.
Remove unauthorized extensions to the wa-
▶
discharge hose. Connect device
Start/Refill was not pressed.
Press Start/Refill.
▶
Strainer in the water supply is clogged.
Clean the strainer in the water supply → Page 50 .
▶
Water tap is closed.
Open the water tap.
▶
Water supply hose is kinked or pinched.
Make sure that the water inlet hose is not
▶
nods or clenches.
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
The program sequence is electronically optimized. This
may lead to changes in the program duration.
No error - no action required.
▶
The imbalance control system eliminates the
imbalance by distributing the laundry several times.
No error - no action required.
▶
Remark: When loading, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
Troubleshooting NL
57
Advertisement
Table of Contents
