Cd Test Mode - Aiwa NSX-R10 Service Manual

CD TEST MODE -1/1

CD TEST MODE Ver. 3.0
1. Starting CD Test Mode
While pressing and holding down the CD OPEN/CLOSE button, insert the AC plug to outlet.
When test mode starts, the message, TEST appears on the display.
2. Exiting CD Test Mode
Press the other function button, POWER button or remove the AC plug from outlet.
3. Function of CD Test Mode
No Mode Function Key
1 Start Mode
2 Search Mode STOP button
3 Play Mode PLAY button
4 Traverse PAUSE
Mode button
5 Sled mode FF button
RWD button
6 Spindle mode
REC MUTE
button
* 1 When Focus Search operates continuously more than 10 minutes, the protection circuit is activated due to heat generation of the driver IC.
In this case, turn off the power, wait for approximately 10 minutes so that heat is released, and then restart.
* 2 When Focus Search fails three times, the gain is switched for CD-RW at the fourth time.
* 3 Be careful not to damage the gear because the sled motor rotates while the FF or RWD button is being pressed even if the pickup is located in
the innermost track or the outermost track.
Display
All lit.
READING
Normal
Normal
TEST
TEST
REC/ All lit.
Movement
FL all lit.
LD constantly lit.
Focus search continuous
movement *1, 2
Spindle motor continuous kick
Normal playback
If TOC READ is unavailable,
focus search is continued.
Tracking servo OFF/ON
OFF and ON is repeated by every
press of the PAUSE button.
PU moves to the innermost position. *3
At the same time, lens is kicked
toward inner position.
PU moves to the outermost position. *3
At the same time, lens is kicked toward
outer position.
When the button is pressed at the first
time, spindle motor rotates forward
(at rough speed).
At the second press, rotation is reversed.
At the third press, rotation stops.
-39-
Check
FL check
Microcomputer check
APC circuit check
Laser current electricity measurement
Focus search waveform check
Focus error waveform check
(DRF is ignored during search mode.)
Each servo circuit check
DRF check
RF frequency check (approx. 1.7Vp-p)
Tracking balance check
Sled circuit check
Tracking circuit check
Mechanism movement check
PU check
Spindle circuit check
Spindle motor check