One-Touch Dialing - NEC AT-55P User Manual

Placing a Call on Hold:
1. With a conversation in progress on the phone.
2. Press the HOLD key.
3. If using the handset, you may put the handset back in the cradle.
4. To converse with the caller again, pick up the handset (or press the SPEAKER key).

One-Touch Dialing

This telephone is equipped with 10 one-touch dial memory keys for programming your most
frequently dialed telephone numbers. You can store up to 21 digits in each one-touch key. When
using this telephone as a PBX extension, you may need to include a Trunk Access Code followed
by a pause to gain an access to an outside line.
Index Label:
Surrounding the one-touch keys is an index label. When numbers are entered into the one-touch
keys, remove the plastic cover and make a note against each key to remind you which number is
stored in the memory.
To Store a Number in the One-Touch Key:
1. Ensure the phone is idle.
2. Dial the number you want to store (up to 21 digits). This may include digits 0~9, *, # and
Pause.
3. Press and hold the one-touch key (1-10) for approx. 2 seconds, until you see "SAVE"
shown on the display.
To Change the Number in the One-Touch Key:
You can change a stored number by simply following the storage procedure above. The new
number will overwrite the previously stored number.
To Dial the Number in the One-Touch Key:
1. Press SPEAKER (or lift the handset).
2. Press the desired one-touch key.
3. The stored number is automatically dialed out.
To Preview the Number before Dialing:
1. Press first the desired one-touch key. The stored number is displayed.
2. Press SPEAKER, PBX DIAL, or lift the handset.
3. The stored number is automatically dialed out.
To Delete Stored Number in One-Touch Key Memory
1. Ensure the phone is idle.
2. Press the One-Touch Key desired to delete the memory.
3. Press DELETE more than 2 seconds.
4. The number displayed on LCD is deleted and "-----------" is appeared.
12
FEATURES