Crow FW2-SIREN2EXT-8/9F Installation Manual page 7

- User Guide
Siren's Jumper's MODE SET-UP
Jumper No.
A
B
C
D
Note:
and area B if system is partitioned
P50E1E: Turn off option 1.
P52EE1E: Turn off option 1.
Mnemonic
<PROG>
<ENTER>
Notes:
The learning between the Transceiver to the Siren Units should be performing
before the installation of the Siren Units.
It's recommended to locate the Siren at least 2 meter distance from the
transceiver during the learning mode.
Function if = O (Open)
Not in used for RUNNER 2 and
SERENITY control panels
NO Flashes with ARM/Disarm
NO Beeps with ARM/Disarm
2 Min Time out
On control panel must disable Arm/Disarm chirps from Output‐1 for area A
Description
PROGRAM key.
Enter key.
Press key or enter parameter
Table 1: Jumpers set-up.
Function if =1 (Close)
Flashes appear with ARM/Disarm
Arm: 2 Flashes (@LOW BAT 3+3
Flashes)
Disarm: 1 Flash (@LOW BAT 2
Flashes)
Beeps sound with ARM/Disarm
Arm: 2 Beeps(@LOW BAT 3+3
Beeps)
Disarm: 1 Beep (@LOW BAT 2
Beeps)
15 Min Time out
5