Table of Contents
Advertisement
ELPMBUNI
Securing the Upper Assembly Ceiling Plate
1.
Review your projector's distance calculation to determine what distance is recommended from the front of
the lens to the edge of the screen for best picture ratio.
2.
Locate the inverted projectors top of the lens point to a point centered horizontally on the screen and no
higher then the top image edge of the screen).
3.
It is normally better to have the top edge of the lens as close to parallel with the top image edge of the
screen as well.
4.
Before you mount your screen and projector, make sure the mounting location will safely support the
weight of the projector.
NOTE: Make sure to measure from the center of the mounting bracket to the front edge of the lens to
determine the proper placement of the center of the upper assembly.
NOTE: If installing the security kit (ELPMBSEC), please refer to the security kit installation guide
before attaching the ceiling plate to the ceiling or wall.
5.
Secure the ceiling assembly into a solid wood ceiling stud with the three (3) #14 x 2" wood screws
(supplied) or with other (commercially available) hardware depending on your installation environment
(Figure 9).
Ceiling Structure
Wood Screws
Upper Assembly
Installation Manual
Secure the ceiling mount to the center of the wood
stud.
Figure 9
Ceiling Wood Stud
Knurl Knobs (3ea)
Page - 15 -
Advertisement
Table of Contents
