Firehawk FHB10W Instructions

Pairing Radio Linked Alarms Instructions

CONNECT

1
1.0 Plug alarm into pattress and switch on radio
base, the pattress led will flash green twice per
second. If not please complete step 6.0

ALARM ASSEMBLY

2
2.0 Bring alarm & radio base together then twist/slide to lock into place.
Wait for smoke or heat alarm to
Connect and assemble all of the alarms in your system before starting the pairing process.

PAIRING TWO ALARMS

3
3.1 Group the alarms on the right hand side of your
table, then place two alarms in front of you spaced
approximately 20cm APART.
3.2 Press the TEST BUTTON on one alarm and wait
THREE SECONDS.
3.3 Press the TEST BUTTON on the other alarm.
3.4 Watch carefully as both alarms FLASH
AND RED
3.5 As soon as one FLASHES
3.6 The other alarm will continue to FLASH
FLASH GREEN
3.7 There is now a 10 SECOND WINDOW to allow another device to be added to the system
If no other devices are to be added proceed to Step 5.0
3.1
20cm
PLEASE read all instructions BEFORE beginning to pair a system!
SMOKE ALARM
BEEP TWICE
GREEN
GREEN ONLY, move it to the left of the table.
GREEN
(CO x4) THE TWO ALARMS ARE NOW PAIRED.
3.2
PRESS
& WAIT
FOR 3
SECS.
FHB10W HEAT ALARM FHH10W
Wait for the CO alarm to
3.2
PAIRED
AND RED BEEPS
until it
3.3 3.4
CO ALARM CO7B (10Y)W
BEEP FOUR TIMES
3.3
20cm
UNPAIRED
ALARM(S)
,then it will
3.5
PAIRED