Firehawk FHB10W Instructions

Pairing Radio Linked Alarms Instructions

CONNECT

1
1.0 Plug alarm into pattress and switch on radio
base, the pattress led will flash green twice per
second. If not please complete step 6.0

ALARM ASSEMBLY

2
2.0 Bring alarm & radio base together then twist/slide to lock into place.
Wait for smoke or heat alarm to

PAIRING TWO ALARMS

3
3.1 Place two alarms on the table spaced approximately
20cm APART.
3.2 Press the TEST BUTTON on one alarm and wait
THREE SECONDS.
3.3 Press the TEST BUTTON on the other alarm.
3.4 Watch carefully as both pattresses
AND RED
3.5 As soon as one FLASHES GREEN
3.6 The other pattress will continue to flash red/green until it
BEEP
(The CO will
3.7 There is now a 10 SECOND WINDOW to allow another device to be added to the system Step 4.0
If no other devices are to be added proceed to Step 5.0
3.1
20cm
PLEASE read all instructions BEFORE beginning to pair a system!
SMOKE ALARM
BEEP TWICE
(Repeat steps 1.0 and 2.0 for each alarm)
FLASH GREEN
ONLY, move it to one side.
FOUR TIMES) THE TWO ALARMS ARE NOW PAIRED.
3.2
PRESS
& WAIT
FOR 3
SECS.
FHB10W HEAT ALARM FHH10W
Wait for the CO alarm to
3.2
PAIRED
BEEPS
,then it will
3.3 3.4
CO ALARM CO7B (10Y)W
BEEP FOUR TIMES
3.3
20cm
UNPAIRED
ALARM(S)
FLASH GREEN
3.5
PAIRED