Wall Mounting - Panasonic WJ-NX100/2E Installation Manual

Network disk recorder
Hide thumbs Also See for WJ-NX100/2E:
Table of Contents

Advertisement

2 Installation

Wall mounting

To install the recorder on a wall, the rack mount bracket WV-Q202 (with 2 pieces in one set, optional) is required.
STEP1
Remove the screws (×2) behind both sides of the
recorder.
Store the removed screws (M3 × 6 mm) properly.
STEP2
Attach the rack mount bracket (WV-Q202: optional)
onto both sides of the recorder.
Secure them using four rack mount bracket mounting
screws (provided with WV-Q202).
• Tightening torque:
0.69 N·m ~ 0.88 N·m (7.0 kgf·cm ~ 9.0 kgf·cm)
{0.51 lbf·ft ~ 0.65 lbf·ft}
Note:
• The following mounting bracket and screws provided
with the rack mount bracket WV-Q202 is used.
Rack mount bracket × 1
M3×10 mm × 4
Rack mount bracket mounting screw
(M3 × 10 mm: provided with WV-Q202) × 4
14
(continued)
STEP3
Mount the recorder vertically on the wall.
Secure it onto the wall using 4 mounting screws (M5, 10 mm
or longer, locally procured).
Important:
• When installing the recorder on a wall, the height should
be no more than 2 m {6.6 ft}.
• Make sure that the minimum pullout strength of the
mounting screws is 196 N (20 kgf) {44 lbf} per screw.
• Select the type of screws according to the material of
the wall. Do not use wood screws or nails.
• Adequately reinforce the wall when mounting on a wall
that is not strong enough, like a wall made of gypsum
boards.
• The operating temperature of the recorder ranges from
+5 °C to +45 °C {41 °F - 113 °F}.
* When the temperature of HDD rises, the features may
deteriorate and the service life may be affected. It is
recommended to use the recorder (including the AC
power adapter) at approx. +25 °C {77 °F}.
• Route the cables (including the DC cable of the AC power
adapter) properly so that they will not be pulled or bent
and the AC power adapter will not be hung in the air.
Note:
• If you install the recorder on a wall in the direction as
shown in the above-mentioned STEP 3, the cooling fan
outlet on the rear panel will be located at the top, and
the cooling effect will be higher.
Cooling fan outlet

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wj-nx100

Table of Contents