AEG SBE 600 R Instructions For Use Manual page 6

Positioning the
auxiliary handle
Switching over
drilling
percussion
drilling
Changing gear
(not for
SBE 600 R)
Speed selection
(not for
SB2–700)
Switching
between forward
and reverse
rotation
(not for
SB2–700)
Switching the
machine on and
off
ENGLISH
The auxiliary handle can be positioned as
required. Loosen the clamping by twisting
the auxiliary handle, bring the auxiliary
handle into the required position and
re–fasten the handle.
(according to standard equipment)
Turn changeover lever to symbol
percussion drilling.
Turn the switch to position
in metal, plastic, and wood, and for
screwdriving.
The gears can be changed when the
machine is switched off or is running under
no load.
Gear change lever in position 1: 1st gear
Gear change lever in position 2: 2nd gear
A = lowest r.p.m.
F = highest r.p.m.
The speed can be controlled in infinitely
variable steps up to the speed
preselected at the speed dial, according to
the finger pressure on the On-/off switch.
During continuous operation with switch
locked in the position the machine will run
at the pre–selected speed.
Select direction of rotation with reversing
lever.
Due to a lockout mechanism, the reversing
lever can only be switched when the
On-/off switch is not depressed.
Only change direction of rotation when the
machine has stopped.
Intermittent use
Switching on: Press On-/off switch
Switching off: Release On-/off switch
Continuous use
Switching on: Press the On-/off switch and
then the locking button, after that release
on-off switch.
Switching off: Press the On-/off switch and
then release.
The speed can be controlled in infinitely
variable steps up to the speed
preselected at the speed dial, according to
the finger pressure on the On-/off switch.
5
SBE 600 R, SB2E 680 R, SB2-700, SB2E 700 R, SB2E 700 RS, SB2E 705 PLUS, SB2E 750 R, SB2E 760 R
for
for drilling
2
1
1
2