Installing A Tape Drive - Compaq 3U RM Storage Enclosure Reference Manual

2-2 Compaq 3U RM Storage Enclosure Reference Guide

Installing a Tape Drive

To set or change the SCSI ID of a tape drive, refer to your tape drive manual
for setting the SCSI ID.
IMPORTANT: If you are returning a failed tape drive, DO NOT return the slide-out drive
tray.
Perform the following steps to remove and install a tape drive:
1. Power down the storage enclosure.
2. Open the top access door of the enclosure.
3. Remove the shipping screw from the slide tray next to the thumbscrew.
4. Loosen the thumbscrew.
5. Remove the slide-out drive tray by pushing the tray toward the rear of
the storage enclosure 1. Then, grab the front of the tray and pull the tray
out at an angle 2.
Figure 2-1. Removing the empty slide-out drive tray
6. Remove the drive blank(s) by applying gentle pressure to the center of
the bezel and pulling on one end of the bezel.
1
2