Fujitsu PRIMERGY TX300 S3 Service Supplement Manual page 31

Replacement routines
Figure 12: Removing the screws
Ê Remove the two screws (see the arrows) and take out the intrusion switches
inward.
Ê Pull the first removed intrusion switch out of the cable clamp.
Ê Remove the intrusion switch cable from the connector on the system board
(see also the Technical Manual of the system board).
V
CAUTION!
Note the cable routing.
Ê Plug the new intrusion switch cable to the connector on the system board.
Ê Route the intrusion switch cable. Lay the intrusion switch with the two wires
over the server's edge as shown in the figure above.
Ê Position the intrusion switch with the three wires on the front cover and
fasten it with two screws.
TX300 S3
Replacing the intrusion switches
Service Supplement 31