Replacing The System Board - Fujitsu PRIMERGY TX300 S3 Service Supplement Manual

Replacing the system board

Ê Close the server and connect all power plugs (for a detailed description see
the Options Guide).
I
After installing the new IDTEMP combo, it is necessary to program the
ChassisID prom with the help of the "ChassisIDProm Tool" to enable
ServerView and ServerStart to identify the system. You will find the tool
on the ServerSupport CD and/or it can be downloaded from the Fujitsu
Siemens Computers Service and Support page (URL:
http://extranet.fujitsu-siemens.com/service/information/intelservers/tools).
4.8 Replacing the system board
Ê Open the server as described in the
Ê Lay the server on a table with the uncovered side facing upward. Place the
server in such a way that the feet can project over the edge.
Ê Remove all external cables.
Ê Remove all controllers from their slots (for a description see the Operating
Manual and the Options Guide). Take note of the slots of the controllers and
the cabling.
Ê If installed: Remove the RAID key and the cache module (for a description
see the Options Guide).
Ê Remove the processor fan holder (see the
fan holder" on page
Ê Remove the heat sink holder, the heat sinks and the processors (for a
description see the Options Guide).
Ê Remove the memory modules (for a description see the Options Guide).
Ê Remove all cables which may be connected to the system board.
Ê Remove the four system fans from the fan cages on the system board.
Ê Loosen the captive screw of each fan cage and remove the four fan cages.
34
section "Preparation" on page
20).
Service Supplement
Replacement routines
section "Replacing the processor
17.
TX300 S3