Assembly - HAMPTON BAY 46-NS Use And Care Manual

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (L) from the canopy (C) by turning
the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (JJ) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (KK) in the round
holes. This will enable you to remove the mounting bracket
(A).
JJ
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrew (LL) on the collar
(M) on top of the fan-motor assembly (D).
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (M) on top of the fan-motor assembly (D).
□
Carefully insert the hanger pin (BB) through the holes in the
collar (M) and downrod (B). Be careful not to jam the hanger
pin (BB) against the wiring inside the downrod (B).
□
Insert the locking pin (CC) through the hole near the end of
the hanger pin (BB) until it snaps into its locked position.
□
Re-tighten the setscrews on the collar (M) on top of the
fan-motor assembly (D).
2
Routing the wires
□
Route the wires exiting the top of the fan motor
assembly (D) through the center of the canopy ring (L).
Make sure the slots on the canopy ring (L) are on top.
□
Insert the ball/downrod (B) through the canopy (C) and
slide the decorative motor collar cover (F) onto the end
of the ball/downrod (B). Make sure the slots on the
canopy (C) are on top.
□
Route the wires exiting the top of the fan motor
assembly (E) through the downrod (B) as shown.
A
KK
C
L
BB
7
Please contact 1-855-HD-HAMPTON for further assistance.
C
L
B
F
D
C
L
B
F
CC
LL
M
D
HAMPTONBAY.COM