Epson ES-800C User Manual page 4

ES-800C
Option error
This indicates a problem such as a paper jam with an
installed option unit.
Check the option unit and correct the cause of the trouble.
Self Test
To run the self test, follow the instructions below:
1. Set the SCSI ID switch to 8.
2. Turn on the power while holding down the
Continue holding the
RESET
complete. (It takes approximately 10 seconds for self test
initialization to complete. Watch for the LEDs to change in
the sequence described below to tell that initialization is
complete.)
Just after power on:
Power LED (green) - O N
Ready LED (green) - O F F
Error LED (red)
After a few seconds:
Power LED (green) - O N
Ready LED (green) - O N
Error LED (red)
After a few more seconds:
Power LED (green) - O N
Ready LED (green) - O F F
Error LED (red)
Finally, all LEDS are lit
3. You can now release the
begins, and the scanner operates automatically.
4. You can stop the self test either by pressing
turning the power off.
RESET
button until initialization is
- O F F
- O F F
- O N
button. The self test mode
RESET
RESET
Options
Option Name
Automatic Document 8813011
. ~
Feeder (ADF)
button.
Bidirectional Parallel
Interface Kit
Kit
Mac Interface Kit
Bidirectional Parallel
Interface Board for
the PC
Bidirectional Parallel
Cable
Interface Kit Contents
BIDIDOS interface Kit
or
SCSIDOS Intetfkce Kit
3 TWAIN Scanner Driver
3 SCSI Interface Board for the PC
ESMAC Intetface Kit
11 f2f92
Number
Feeds up to 30 sheets. Replaces
scanner cover, but still allows
scanning of individual items.
I I
negatives. and transparencies.
Replaces scanner cover, but still
allows scanning of individual
items. Allows scanning of items up
to 5"x 5".
Includes bidirectional parallel
BIDIDOS
board for the PC, cable, TWAIN
scanner driver, and image editing
software.
Includes SCSI board for the PC,
SCSIDOS
cable, TWAIN scanner driver, and
image editing software.
I
(PIM) and Desk Accessory (DA),
cable, Epson Apple Scanner
Driver, and image editing software.
customers who already have
scanning software. Provides a
bidirectional port in the PC to
connect to the parallel interface in
the scanner.
Available separately from kit for
Cl-SE-A
customers who already have
Scanners