Making Ot Terminals By Using A Cable Peeler (Recommended) - Huawei RRU3908 V1 Installation Manual

Appendix
b

Making OT Terminals by Using a Cable Peeler (Recommended)

Add two OT terminals to the end of the power cable connecting to the RRU.
-48V DC power cable
Shielding layer
0 10 20 30 40
15mm
The assembling of OT terminals to the power cable must be complete before the RRU is installed on a
metal pole.
NEG ( - )
RTN ( + )
14mm
8mm
Label for preparing
the power cable
OT terminals
Determine lengths of power cables for different
operations according to the scales on the inner
side of the cover plate of the cabling cavity.
Based on the determined length, remove the
jacket and shielding layer off the power cable.
Remove the jacket from each wire.
Add an OT terminal to each wire.
Strip a 15 mm jacket off the power cable to
reveal the shielding layer of the power cable
36