Problem With Results - Siemens WM6HXE0LDN User Manual And Assembly Instructions

Problem with results

Fault
Creasing.
The spin result is not satis-
factory. The laundry is too
wet/too damp.
Detergent residue on the
damp washing.
Cause
The spin speed is too high.
The load is too large.
The wrong programme is se-
lected for the type of fabric.
A low spin speed is selected.
Less Ironing is activated.
The unbalanced load detec-
tion system has interrupted
the spin cycle because the
laundry is unevenly distrib-
uted.
Detergents may contain wa-
ter-insoluble substances that
deposit on the laundry.
Unsuitable detergent added
to the dispenser of the intelli-
gent dosing system.
Basic dosage is not correctly
adjusted.
Troubleshooting en
troubleshooting
The next time you run a wash cycle,
▶
set a lower spin speed.
The next time you run a wash cycle,
▶
reduce the amount of laundry being
loaded.
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 29
The next time you run a wash cycle,
▶
set a higher spin speed.
Start the Spin programme.
▶
Select the programmes that are
▶
suitable for the type of fabric.
→ "Programmes", Page 29
Redistribute the laundry in the
▶
drum.
Note: Where possible, mix large and
small items in the drum. Different sized
items of laundry distribute themselves
better during the spin cycle.
Start the Spin programme.
▶
Start the Rinse programme.
▶
Check whether the detergent used
1.
is suitable.
→ "Detergents and care products",
Page 41
Drain the dispenser.
2.
→ "Cleaning the detergent drawer",
Page 54
Clean the dispenser.
3.
Refill the dispenser.
4.
→ "Filling the dispenser", Page 46
If intelligent dosing is activated, re-
▶
duce the "basic dosage"
→ Page 47.
67