Setting The Dip Switches - Epson ES-300C Manual

Pressing this button increases the zoom value (in increments of 1%)
between 50% and 200% and increases the brightness value in
increments of 1 between seven values, from -3 (lightest) to 3
(darkest). Use this button to adjust zoom and brightness only when
you are using the direct print function.
Pressing this button decreases the zoom value (in increments of 1%)
50% to 200% and decreases the brightness value in inuements
from
of 1 between seven values, from -3 (lightest) to 3 (darkest). Use this
button to adjust zoom and brightness only when you are using the
direct print function.
Pressing ZOOM/BRIGHT and 0 simultaneously enables the direct
print function.
Self test function
By holding down @or @while you turn on the scanner, you CM
start the scamefs self test function. See Chapter 1 for more
information.
Direct print function
The direct print function transfers a color image directly from your
scanner to your printer. To use the direct print function you must
have a special parallel interface cable. Consult your dealer to obtain
the proper cable. press down both the ZOOM/BRIGHT and@ buttons 1 D,P sw
to start the direct print function. See Appendix D for more
i n f o r m a t i o n .

Setting the DIP Switches

DIP awitcb 1 settings
direct print function.
l - l
Scanners
DIP switch 2 settings
DIP switch 2 determines the scanner operation normally required
for the direct print function. For normal
scanner software sets these scanner functions and overrides the
current DIP switch settings. Therefore, except for the direct print
function, you are unlikely to
factory settings.
Table 4. DIP switch 2
2-2
OFF
ON
OFF
Table 3. Printer type for
direct
O
ON
change
settings
2-l
2.4
2 6
I
I
ES-300C SCANNER
print
2.7 24 2-2
ld
N
ON ON
operations, your
these switches from the
ON
OFF
OFF
ON
I I
ES-300C-3
l-7