Table of Contents
Advertisement
Handset
¤
Connect the flat plug on the power
adapter
.
1
¤
Plug the power adapter into the plug
socket
.
2
Setting up the handset for use
The display is protected by a plastic film. Please remove the protective film!
Inserting the battery and closing the battery cover
Only use a rechargeable battery, as this could otherwise result in significant health
risks and personal injury. For example, the outer casing of the battery could be
destroyed or the battery could explode. The device could also malfunction or be
damaged as a result of using batteries that are not of the recommended type.
¥
Insert the batteries (for
correct +/- direction, see
diagram).
Charging the batteries
¤
Charge the batteries fully prior to first use in the
charging cradle/base.
The batteries are fully charged when the power
icon
disappears from the display.
Batteries may heat up during charging. This is not dangerous.
After a time, the charge capacity of the battery will decrease for technical reasons.
Handsets contained in the package have already been registered to the base. In the
event that a handset is not registered however, (indicated by "Please register hand-
set"), register the handset manually (
10
To remove the plug from the charging cradle
again:
¤
Disconnect the power adapter from the mains
power supply.
¤
Press the release button
¤
Pull out the plug
2
¥
Fit the cover from the top
¥
Then press the cover until it
clicks into place
2
p. 41).
.
4
1
.
To open the battery cover:
1
¥
Push the cover down
.
.
3
3
.
3
Advertisement
Table of Contents
