Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
DATA PLATE DETAILS:
The data plate is located on the front side of the tray.
CHECK THAT THE DATA PLATE SHOWS THAT THE APPLIANCE IS
SUITABLE FOR THE AVAILABLE GAS SUPPLY.
1.
Before installing the appliance check that the location provides the required
clearances from combustible materials and if necessary provide protection
to adjacent surfaces as required by the regulations. Make provision for the
gas supply to be connected in the position shown in Diagram A.
2.
Cut the opening in the bench top to the dimensions shown in diagram B.
3.
Remove the hotplate from the carton.
Models: ER70962HK / ER70926HK / ER70922HK
If clearance between side and rear walls and periphery of the burner is less
than 150mm, the walls must be protected with a non-combustible material.
The protection must extend a minimum distance of 450mm above the burner.
Horizontal surfaces less than 750mm vertically above the hotplate must also
be protected.
Refer – Gas fitting manual. Position of gas inlet
Depth from top of glass to bottom of tray
Models: ER70762HK
Gas Inlet
Gas inlet
4
: See diagram above
: 70mm excluding regulator
Hide quick links:
Advertisement
Chapters
Table of Contents
