Related Manuals for HIKOKI PDA-125M
Summary of Contents for HIKOKI PDA-125M
- Page 1 Disc Grinder PDA-125M Handling instructions Read through carefully and understand these instructions before use.
- Page 2 15°~30° Wrench Wrench Tighten Tighten Washer nut Convex side Wheel nut Convex side Depressed Sanding disc center wheel Wheel washer Rubber pad Spindle Spindle Wheel guard Notched part Push button Push button Wrench Wrench Tighten Wheel nut Wheel nut Cutting wheel Diamond wheel Wheel washer Wheel washer...
-
Page 3: General Power Tool Safety Warnings
Carrying power tools with your fi nger on the switch or GENERAL POWER TOOL SAFETY WARNINGS energising power tools that have the switch on invites accidents. WARNING d) Remove any adjusting key or wrench before Read all safety warnings and all instructions. turning the power tool on. -
Page 4: Safety Warnings Common For Grinding Or Abrasive Cutting-Off Operations
Cutting accessory contacting a “live” wire may make SAFETY WARNINGS COMMON FOR GRINDING exposed metal parts of the power tool “live” and shock OR ABRASIVE CUTTING-OFF OPERATIONS the operator. k) Position the cord clear of the spinning accessory. a) This power tool is intended to function as a grinder If you lose control, the cord may be cut or snagged or cut-off... -
Page 5: Safety Warnings Specific For Grinding And Abrasive Cutting-Off Operations
SAFETY WARNINGS SPECIFIC FOR GRINDING GENERAL SAFETY INSTRUCTIONS FOR AND ABRASIVE CUTTING-OFF OPERATIONS GRINDERS a) Use only wheel types that are recommended for – Check that speed marked on the wheel is equal to or your power tool and the specifi c guard designed for greater than the rated speed of the grinder;... -
Page 6: Specifications
5. RCD The use of a residual current device with a rated residual current of 30 mA or less at all times is recommended. SPECIFICATIONS Model PDA-125M Power Source 230 V 50 Hz Power Input 715 W No-load speed 10 000 /min Wheel size Max. -
Page 7: Practical Grinder Applications
7. Confi rming and mounting the depressed center ASSEMBLING AND DISASSEMBLING wheel. THE DEPRESSED CENTER WHEEL (Fig. 3) Thoroughly check that a specifi ed depressed center wheel is free of cracks and splits is mounted. CAUTION Confi rm that the depressed center wheel is mounted Be sure to switch power OFF and disconnect the under the specifi... -
Page 8: Maintenance And Inspection
In the operation and maintenance of power tools, the safety regulations and standards prescribed in each country must be observed. NOTE Due to HiKOKI’s continuing program of research and development, the specifi cations herein are subject to change without prior notice. Code No. C99257611 I...
Need help?
Do you have a question about the PDA-125M and is the answer not in the manual?
Questions and answers