BMW R nineT 2020 Rider's Manual page 60

54 OPERATION
All functions are sustained even
if the internal battery of the
DWA anti-theft alarm system is
flat; the only difference is that
an alarm cannot be triggered
if the system is disconnected
from the motorcycle's battery.
The alarm signal continues for
approx. 26 seconds. While a
DWA alarm is in progress an
alarm tone sounds and the turn
indicators flash. The type of
alarm tone can be set by an au-
thorised BMW Motorrad dealer.
If a DWA alarm was triggered
while the motorcycle was un-
attended, the rider is notified
accordingly by an alarm tone
sounding once when the igni-
tion is switched on. The DWA
LED then indicates the reason
for the DWA alarm for one
minute.
Light signals issued by the
DWA LED:
Flashes 1x: Motion sensor 1
Flashes 2x: Motion sensor 2
Flashes 3x: Ignition switched
on with unauthorised vehicle
key
Flashes 4x: Disconnection
of the DWA anti-theft alarm
from the motorcycle's battery
Flashes 5x: Motion sensor 3
Deactivating DWA
Switch on the ignition (
Turn indicators flash once.
DWA is switched off.
Adjusting DWA settings
Switch on the ignition (
Select SETUP (
Repeatedly short-press but-
ton 1 until
SET DWA
played.
Short-press button 2 to
change the set value.
The following settings are avail-
able:
: The DWA anti-theft
DWA ON
alarm is active and will be
armed automatically when the
ignition is switched off.
: The DWA anti-theft
DWA OFF
alarm is deactivated.
Long-press button 1 to exit
.
SET DWA
SETUP ENTER
38).
38).
49).
is dis-
is displayed.