BMW R nineT 2020 Rider's Manual page 37

ASC/DTC self-diagnosis not
completed
flashes.
Possible cause:
ASC/DTC self-diagnosis
not completed
The ASC/DTC function is
not available, because self-
diagnosis did not complete.
(The motorcycle has to reach
a defined minimum speed
with the engine running for
the wheel-speed sensors to
be checked: min 5 km/h)
Pull away slowly. Bear in
mind that the ASC/DTC
function and dynamic engine
brake control are not available
until self-diagnosis has
completed.
ASC/DTC switched off
lights up.
Possible cause:
The rider has switched off the
ASC/DTC system.
Switch on the ASC/DTC func-
tion ( 55).
ASC/DTC fault
lights up.
Possible cause:
The ASC/DTC control unit has
detected a fault. The ASC/DTC
function and dynamic engine
brake control are not available
or their functionality is subject
to certain restrictions.
You can continue to ride.
Bear in mind that the ASC/
DTC function and dynamic
engine brake control are not
available or are restricted.
Bear in mind the more
detailed information on
situations that can lead to an
ASC/DTC fault (
Have the fault rectified as
quickly as possible by a spe-
cialist workshop, preferably an
authorised BMW Motorrad re-
tailer.
Anti-theft alarm battery flat
with anti-theft alarm (DWA)
is displayed.
This error message shows
briefly only after the Pre-
Ride-Check completes.
Possible cause:
The integral battery in the anti-
theft alarm (DWA) has lost its
entire original capacity. There
is no assurance that the DWA
anti-theft alarm will be opera-
31
102).
OE