Epson PowerLite 9300i Supplementary Manual
  1. Manuals
  2. Brands
  3. Epson Manuals
  4. Projector
  5. PowerLite 9300i
  6. Supplementary manual
Epson PowerLite 9300i Supplementary Manual

Epson PowerLite 9300i Supplementary Manual

Epson powerlite 9300i: supplementary guide
Hide thumbs Also See for PowerLite 9300i:
1
2

Advertisement

Table of Contents

See also: User Manual , Quick Manual
Epson PowerLite 9300i Notice
®
If dust accumulates in the lamp filter, it can cause overheating and reduce the life of the lamp.
Epson recommends cleaning the lamp filter every three months; clean it more often if the projector
is used in a dusty environment.
Caution: If the temperature light comes on, the projector may be overheating. Clean the lamp filter as described
below. Also be sure to check the air filters on the bottom of the projector; see your User's Guide for details.

Cleaning the Lamp Filter

Follow these steps to clean the lamp filter:
1. Turn off the projector.
2. When the power light stops flashing, unplug the power cord.
3. Let the projector cool for at least half an hour (if it has been on). The lamp is extremely hot
immediately after use.
4. If the projector is mounted on the ceiling, remove the rear cover.
Rear cover
5. Loosen the lamp cover screws (you don't need to take them
out all the way). Then remove the cover.
®
Release tab to
remove rear cover
Cover

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PowerLite 9300i and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Epson PowerLite 9300i

Summary of Contents for Epson PowerLite 9300i

  • Page 1: Cleaning The Lamp Filter

    If dust accumulates in the lamp filter, it can cause overheating and reduce the life of the lamp. Epson recommends cleaning the lamp filter every three months; clean it more often if the projector is used in a dusty environment.
  • Page 2 8. Hold the shutter open, and use a vacuum cleaner to remove any dust from the wire mesh filters inside. 9. Insert the lamp back into the projector, tighten its screws, and replace the lamp cover. Epson is a registered trademark of SEIKO EPSON CORPORATION.

Table of Contents