Main Icons
Installation and Start-Up
Installation
Intro
Operation
Customer
Mounting and Connections continued
Assistance
External Speaker
External Speaker Jack
The speaker jack on the rear panel is used for an External Speaker.
Customer
Installation
Assistance
The external speaker should have 8-Ohm impedance and be rated
to handle at least 4.0 watts. When the external speaker is plugged
Secondary Icons
in, the internal speaker is automatically disconnected.
NOTE
Cobra external speakers are rated 15 watts.
Notice
Caution
Power
Power Cable
Installation
Installation
These wires supply Power to the CB radio.
This cable is permanently attached to the radio.
If you wish to remove the radio after installation,
disconnect at fuse holder and ground connector.
CB Antenna
Only a properly matched Antenna system will allow maximum power output. In mobile
installations (cars, trucks, boats, etc.), an antenna system that is nondirectional should be used.
When installed in a boat, the transceiver will not operate at maximum efficiency without a ground
plate unless the vessel has a steel hull. Before installing the transceiver in a boat, consult your
dealer for information regarding an adequate grounding system.
NOTE
Cobra offers a line of antennas for use with your 19 Series CB Radio.
Go to cobra.com/collections/cb-radio-accessories for antenna and antenna mounting options.
Microphone Connector
Microphone Connector
Allows for convenient removal of the Microphone plug
when storage is required. The Microphone MUST be
connected to the unit at all times, when in use, for
proper operation.
English
4
Warranty
Warning
Main Icons
Operating Your CB Radio
Intro
Display
•
Secondary Icons
E
A.
TX Icon
B.
AM Icon
C.
Auto Squelch Icon
D.
Channel
E.
Key Tone Icon
Operation
Operation
Customer
Warranty
Assistance
Customer
Installation
Assistance
A B C
D
Notice
Caution
Warning
F G
H
I
F.
S/RF Meter
G.
Channel Lock Icon
H.
Channel Frequency
I.
VOX Icon
•
VOL
5