Secondary Icons; Included In This Package; Installation And Start-Up; Mounting And Connections - Cobra 19 MINI Owner's Manual

Operation

Included in this Package

Notice Caution Warning
Introduction
Intro Operation
You should find all of the following items in this package:
Installation
CB Transceiver

Secondary Icons

Microphone Bracket
Operating Manual
English
2
Customer Warranty
Assistance
Customer
Assistance
Microphone
Notice Caution Warning
Transceiver Bracket
Intro Operation
Introduction Installation
Intro

Mounting and Connections

Installation
Select a location for the transceiver and microphone bracket that is convenient for Secondary Icons
s n o I c
operation. In automobiles, the transceiver is usually mounted to the underneath of the
dash panel, with the microphone bracket beside it.
Transceiver Bracket
Notice
Secondary Icons
e r m o s t u C n i o a t e r p O o t r I n
y n t r a a r W
e c n a i s t s s A
CB Tranceiver
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A
Antenna Connector
Main Icons
s n o I c y a r d n
s n o I c
n i o u t a C e i c o t N
Intro
g n n i a r W
Fuse Connection
e r m o s t u C n i o a t e r p O o t r I n
y n t r a a r W Secondary Icons
e c n a i s t s s A
e r m o s t u C
n i o a t a l l s t I n
e c n a i s t s s A
Microphone Connector
s n o I c y a r d n
n i o u t a C e i c o t N
g n n i a r W
NOTE
For improved CB radio performance, connect the radio power leads directly to the
vehicle battery. This helps to ensure the following: 1) reduces conducted power line noise
into radio by taking advantage of the mechanical filtering properties of the vehicle battery.
2) Using the correct wire gauge between the battery and radio, helps to minimize Voltage
drop to the radio transmitter section to maximize transmitter RF output power.
Customer Warranty
Assistance

Installation and Start-Up

Customer
Operation Customer Warranty
Assistance
Assistance
n a i M
Customer
Installation
A universal mounting bracket is supplied along with self-tapping Assistance
screws and star washers. The transceiver is held in the
Caution Warning
universal mounting bracket by two thumb screws, permitting
adjustment at the most convenient angle.
To mount and connect your transceiver:
1. Hold the radio with mounting bracket in the exact
Notice Caution Warning
location desired. Remove the mounting bracket
and use it as a template to mark the location for
the mounting screws.
o c e S
2. Drill necessary holes and secure mounting
bracket in location.
3. Connect the antenna cable plug to the receptacle
n a i M
marked "ANT" on the back of the unit.
Operation Customer Warranty
Assistance
4. Connect the red lead of the DC power cord
to an accessory 12 volt fuse.
Customer
5. Connect the black lead to the negative side
Installation
Assistance
of the automobile. This is usually the chassis.
Any convenient location with good electrical
contact (remove paint) may be used.
6. Mount the microphone bracket in a convenient location
Notice Caution Warning
that does not interfere with vehicle operation using the
two screws supplied.
o c e S
7. Connect the microphone RJ-45 plug to the 19 MINI RJ-45
front panel jack. Then install the radio into it's mounting
bracket securely.
•
3