4.2
Installing the Ground Cable
•
The ground point on the enclosure is preferred to connect to the PE cable for the SUN2000.
•
The ground point in the maintenance compartment is mainly used for connecting to the
ground cable included in the multi-core AC power cable. For details, see section " 4.4
Installing AC Output Power Cables."
•
The ground cable must be secured.
•
It is recommended that the ground cable of the SUN2000 be connected to the nearest
ground point. For a system with multiple SUN2000s connected in parallel, connect the
ground points of all SUN2000s to ensure equipotential connections to ground cables.
•
To enhance the corrosion resistance of the PE terminal, apply silica gel or paint on it after
connecting the ground cable.
Opening the Maintenance Compartment Door
4.3
•
Never open the host panel of the SUN2000.
•
Before opening the maintenance compartment door, turn off the downstream AC output
switch and the two DC switches at the bottom.
•
Do not open the maintenance compartment door in rainy or snowy days. If unavoidable, take
protective measures to prevent rain or snow from entering the maintenance compartment.
•
Do not leave unused screws in the maintenance compartment.
1. Loosen the two screws on the maintenance
compartment door using a security torx
wrench.
PE
2. Open the maintenance compartment door
and install the support bar.
6
M8
8 N·m