Huawei SUN2000-50KTL-JPM1 Quick Manual page 13

4. Install the terminal base on the terminal
block, and connect the shield layer to the
ground point.
•
When connecting the shielded cable, choose whether to crimp the OT terminal based on site
requirements.
•
Tie the communication cables with the cables on internal side of the maintenance compartment.
6. Tighten the thread-lock sealing nut and seal the cable gland.
RJ45 Network Port Connection
1. Prepare an RJ45 connector.
No. Color
White-and-
1
orange
2 Orange
3 White-and-green
4 Blue
5 White-and-blue
6 Green
7 White-and-brown N/A
8 Brown
Pin Definition
RS485A, RS485
differential signal+
RS485B, RS485
differential signal–
N/A
RS485A, RS485
differential signal+
RS485B, RS485
differential signal–
N/A
N/A
5. Bind the communications cable.
2. Route the cable through the cable gland.
12