Care And Maintenance; Troubleshooting - Sunbeam Contempo Fire Table Owner's Manual

Care & Maintenance
perform the following maintenance activities on a regular basis:
Keep exterior surfaces clean.
or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around
the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT use
it. It must be replaced.
• Keep the ventilation opening of the cylinder enclosure free and clear from debris.
blockage include:
• Fire pit does NOT reach the desired temperature.
• Fire pit glow is excessively uneven.
• Fire pit makes popping noises.
use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
Note: In a salt-air environment (such as near an ocean), corrosion occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
Storage
Between uses:
• Turn Control Knob OFF.
• Disconnect LP source.
debris).
Note: Wait until fire pit is cool before covering.
During periods of extended inactivity or when transporting:
• Turn Control Knob OFF.
• Disconnect LP source and move to a secure, well-ventilated location outdoors.
debris).
• Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until fire pit is cool before covering.
Service

Troubleshooting

PROBLEM
Burner won't light
Carbon build-up
Thick black smoke
POSSIBLE CAUSE
Propane cylinder is empty
Control knob is not in ON position
Gas pressure is low
Outdoor temperature is less than 40°F
Control knob is fully on
Blockage in burner
WARNING
FOR YOUR SAFETY
minutes after use. Fire pit is hot to the touch.
and protective cover.
CORRECTIVE ACTION
Replace propane cylinder
Clear blockage
Turn control knob to ON
Use a full cylinder
Clean burner
Remove blockage and clean burner inside & outside
1-877-387-3639
, dust and
, dust and
| Page 14