Table of Contents
Advertisement
Care & Maintenance
To enjoy years of performance from your fire table, make sure
you perform the following maintenance activities
on a regular basis:
Keep exterior surfaces clean.
1. Use warm soapy water for cleaning. Never use flammable
or corrosive cleaning agents.
2. While cleaning your unit, be sure to keep the area around
the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOTuse it. It must be replaced.
• Keep the appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air.
• Keep the ventilation opening of the cylinder enclosure free and clear from debris.
3. Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean. Signs of possible blockage
include:
• Gas odor with extreme yellow tipping of flame.
• Fire table does NOT reach the desired temperature.
• Fire table glow is excessively uneven.
• Fire table makes popping noises.
• Spiders and insects can nest in burner or orifices. This dangerous condition can damage fire table and render it unsafe for
use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed air may help clear away smaller particles.
• Carbon deposits may create a fire hazard. Clean burner with warm soapy water if any carbon deposits develop.
Note: In a salt-air environment (such as nearan ocean), corrosion occurs more quickly than normal. Frequently check for
corroded area sand repair them promptly.
Storage
Between uses:
• Turn Control Knob OFF
• Disconnect LP source.
• Store fire table in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).
• Cover re table with lid and protective cover to prevent water from accumulating in the Firebowl Pan and to protect
exterior surfaces. To ensure your new unit withstands our North American winters, we strongly recommend the unit be
stored in a dry area and not sit in a moist cover. Remove access water and snow to protect the unit over the winter.
Note: Wait until fire table is cool before covering.
During periods of extended inactivity or when transporting:
• Turn Control Knob OFF.
• Disconnect LP source and move to a secure, well-ventilated location outdoors.
• Store fire table in an area sheltered from direct contact with inclement weather (such as rain, sleet, hail, snow, dust and debris).
• Cover re table with lid and protective cover to prevent water from accumulating in the Firebowl Pan and to protect
exterior surfaces. To ensure your new unit withstands our North American winters, we strongly recommend the unit be
stored in a dry area and not sit in a moist cover. Remove access water and snow to protect the unit over the winter.
• Never leave LP cylinder exposed to direct sunlight or excessive heat.
Note: Wait until fire table is cool before covering.
Service
Only a qualified service person should repair gas passages and associated components.
Troubleshooting
PROBLEM
Burner won't light
Carbon build-up
Thick black smoke
Page 10
POSSIBLE CAUSE
Propane cylinder is empty
Control knob is not in ON position
Gas pressure is low
Outdoor temperature is less than 4 ˚
Control knob is fully on
Blockage in burner
WARNING
FOR YOUR SAFETY
minutes after use.
Fire table is hot to the touch.
CORRECTIVE ACTION
Replace propane cylinder
Clear blockage
Turn control knob to ON
Use a full cylinder
Clean burner
Remove blockage and clean burner inside & outside
Advertisement
Table of Contents
