Sunbeam Contempo Fire Table Owner's Manual page 13

Operation
Caution: Do not attempt to operate until you have read and understand all Safety Information in this manual and all
assembly is complete and leak checks have been performed.
Before Turning Gas Supply On:
enclosed area.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is replaced
and fastened prior to starting.
Before Lighting:
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak
manufacturer. The burner must be replaced prior to the appliance being put into operation if it is evident that the burner is
Lighting:
1. Make sure the control knob is in the "OFF" position (Figure A).
2. Fully open LP cylinder valve.
Note: For initial start or after any cylinder change, hold Control Knob IN for 2 minutes to purge air from gas lines
before proceeding.
3. Push in gas control knob, turn counterclockwise to "LOW" (Figure B), and press the BLACK ignitor button to light the
(you should hear a clicking sound).
Note: If burner fails to remain lit, all valves should be closed and a waiting period of at least 5 minutes should pass before
attempting to light.
Figure A
OFF
LOW
IGNITOR
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this
10 seconds before igniting the gas will cause a
WARNING
FOR YOUR SAFETY
Fire pit will be hot after use. Handle with extreme
care.
Page 13
Figure B
OFF
LOW
IGNITOR
Re-lighting:
1. Turn control knob to "OFF".
2. Repeat the "Lighting" steps on prior page.
Turn off:
1. To extinguish burner depress control knob and continue to
turn it clockwise to "OFF".
2. Turn cylinder valve clockwise to "OFF" and disconnect
Figure C
OFF
LOW
HIGH
IGNITOR
. If relighting