Electrical Connection - Beko WM 84125W User Manual

Installation

3.7 Electrical connection

Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall
not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy reach
after installation.
• If the current value of the fuse or breaker
in the house is less than 13 Amps, have a
qualified electrician install a 13 Amp fuse.
• The voltage specified in the "Technical
specifications" section must be equal to your
mains voltage.
• Do not make connections via extension
cables or multi-plugs.
B
WARNING:
must be replaced by the Authorised
Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance become
damaged or need replacing at any time, it
must be replaced by a special purpose made
mains lead which can only be obtained from a
Authorised Service Agent.
B
WARNING:
earthed.
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Washing Machine / User's Manual
Damaged power cables
This appliance must be
Destroy the old plug, which is cut off as a plug
with a bared cord could cause a shock hazard if
inserted into a socket elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse need
to be replaced an ASTA approved BS1362 fuse
of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing the
fuse cover, the plug must not be used until a
replacement fuse cover has been fitted. Colour
of the replacement fuse cover must be the
same colour as that visible on the pin face of
the plug. Fuse covers are available from any
good electrical store.
Important
Fitting a different plug
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
1 Connect the green - yellow or green (earth)
wire to the terminal in the plug marked 'E'
or with the symbol f or coloured green and
yellow or green.
2 Connect the blue (neutral) wire to the
terminal in the plug marked 'N' or coloured
black.
3 Connect the brown (live) wire to the terminal
in the plug marked 'L' or coloured red.
13 / EN