Plug In And Turn On; Turning Off The Projector - Epson PowerLite 62c Quick Setup Manual

4

Plug in and turn on

1
Press in the tabs and remove the lens cover.
2
Connect the power cord to the projector and plug
the other end into an electrical outlet.
The
3
If you are connecting a device other than a computer, such as
a DVD player, turn on your equipment. (If you are connecting
to a computer, don't turn it on yet.)
4
Press the
You hear a beep, the
projector lamp comes on in about 4 seconds. The
light stays green.
5
If you are using a computer, turn it on now.
6
Start your video or presentation. If you have
connected more than one video source, press
the Comp1, Comp2, S-Video, or Video button
on the projector remote control to select the
one you want to watch.
NOTE
If you connected a notebook
computer and no image is being
projected, you may need to set up
the notebook to display on an external
device. See the Troubleshooting
section for instructions.

Turning off the projector

1
When you're finished using the projector, first turn off the
video source.
2
Press the
3
When you see the confirmation message, press the
button again. The projector beeps twice, the lamp is turned off,
and the
4
When the
With Epson's exclusive Instant Off
cool-down period, so you can pack up and go immediately
after turning off the projector.
Caution:
Never unplug the projector when the
or flashing orange.
power light turns orange.
Power button on the projector or remote control.
Power button on the projector or remote control.
power light turns orange.
power light is a steady orange, unplug the projector.
power light flashes green, and the
Source buttons
technology there's no
TM
power
Power
power light is green