Advertisement
Nozzle Trajectory Adjustment Procedure
Note: The nozzle trajectory is factory set at 25 degrees.
1. Insert the multi-purpose tool (P/N 995-83) into the slot provided in the top of the cap. Pull the riser assembly up, then grasp the
assembly to hold it in the popped-up position.
2. Remove the cap retaining screw and cap.
3. Using a 5/8" nut driver (P/N 995-99), turn the nozzle/housing assembly left to select 15° trajectory as shown in Figure 8. Turn the
nozzle/housing assembly right to select 25° trajectory as shown in Figure 9.
4. Install the cap making sure the top the nozzle housing is correctly nested in the cap.
5. Install the cap retaining screw.
6 Activate the sprinkler to check the spray trajectory.
Figure 8
Figure 9
Turn Nozzle
Clockwise
_______________________________________
Turn Nozzle
Clockwise
o
15
o
25
7
Advertisement
