Miele Novotronic W 930i Operating Instructions Manual page 28

What to do if . . . ?
What to do if, . . .
. . . the "Soak/Pre-wash" or
"Main wash" or "Rinses 1-2"
or "Rinse 3" LED is flashing?
. . . The "Rinse hold" LED is
flashing?
. . . The "Final spin" LED is
flashing?
. . . The "ON" LED is flash-
ing?
. . . The washing has not
been spun satisfactorily?
. . . The machine shakes
during the spin cycle?
28
All manuals and user guides at all-guides.com
Cause . . .
There is a fault.
The spin speed selector has
been set to "Rinse hold".
The final spin has not taken
place. The machine detected
an imbalance.
Programme locking is
activated. The programme
selected has been changed.
The spin speed selected was
too low.
The load was not distributed
sufficiently evenly in the drum.
Laundry was either only spun
at a reduced speed to protect
the machine
The drain pump and fluff filter
is clogged.
The four feet are not resting
evenly on the floor.
Remedy . . .
– Start the programme again.
If the LED starts flashing
again call the Service Dept.
– Select a spin speed setting.
– Loosen the laundry load.
– The spin speed appropriate
for the programme should
be selected.
– Turn the programme
selector to "Spin".
– Go back to the programme
originally selected.
– Select a higher spin speed
next time.
– Mix large and small items in
a load to avoid imbalance.
– Clean the drain pump and
fluff filter.
– Level the machine (see
Installation Section).