Sharp VL-AX1S/H Service Manual page 15

(5) PLAYBACK (RECORD, FF, VSF) mode
The mechanism position for playback, record, FF and fast
feed playback.
The pinch roller is pressed to the capstan shaft, and the S/Tu
main brake is separated from the S/Tu reel base.
S reel base
S main brake
PLAYBACK mode diagram
(RECORD, FF, VSF)
8-2. Cassette controller assembly
<Removing>
(1) Apply DC3V to the loading motor to enter the standby mode.
Press the lock lever in the arrow direction to raise the cassette controller. (See Fig. 1;
(2) Turn the damper lever in the arrow
(3) Remove two screws , and remove the down guide
E
Take care that the slide chassis is provided with the down guide positioning
(4) Slide the cassette controller in the arrow
and turn the cassette controller in the arrow
(5) Slide the cassette controller in the arrow
<Installing>
(1) Apply DC3V to the loading motor to enter the standby mode.
(2) For assembly, reverse the removing procedure (5) thru (2).
Tightening torque of two screws
Capstan shaft
Pinch roller
Tu reel base
Tu main brake
(Not visible)
direction to release the engagement of the damper bar. (See Fig. 2.)
C
direction, remove the outer link shaft (both sides) toward the inside of the mechanism,
I
direction. (See Fig. 5.)
J
direction. (See Fig. 6.)
K
: 40±4mN.m
E
Fig. 1.
Fig. 3.
Fig. 5.
(6) STOP mode
The system is in the STOP (Rec Lock in CAMERA mode)
position; the S and the T pole bases are snap-fitted to the drum
base, the S brake is in contact with the S reel base, and the Tu
brake is in contact with the Tu reel base.
S reel base
S main brake
in the arrow direction. (See Figs. 3 and 4.)
D F
or
G
Fig. 4.
15
VL-AX1S/H/E/EW/EX
S pole base
T pole base
STOP mode diagram
or direction.)
A B
.
H
Fig. 2.
Fig. 6.
Tu reel base
Tu main brake