Control Panel; Switching Off; Selecting A Heating Circuit For The Standard Display - Bosch Compress Hybrid 7000i AW Operation Manual

Item Symbol Explanation
1 Value display (current temperature):
• Room temperature if a remote control is
installed for the actual heating circuit
• Heat source temperature for installation in
heat source.
2 – Info line: display of time of day, day of the
week and date.
3 Additional temperature display: outside
temperature, temperature of the solar
collector or a DHW system.
4 – Text information: e.g. the designation of the
temperature currently displayed ( Fig. 3,
[1]). If a fault is present, corresponding
information will be displayed here until the
fault has been rectified.
5 The key block is active (hold down the DHW
key and selector to activate or deactivate the
key block).
6 Infographic: solar pump is in operation.
Infographic: DHW heating is active
Infographic: DHW thermal disinfection active
Infographic: Extra DHW active
Infographic: Pool heating active
Infographic: Heating active
Infographic: Cooling active
Infographic: Energy supplier interruption
Infographic: External input active (remote)
Infographic: Holiday mode active
Infographic: Time program active
Infographic: Smart grid function active
Infographic: Screed drying active
Infographic: Electric booster heater active
Infographic: Power guard active
Infographic: Additional heat source active
Infographic: Defrost function active
Infographic: Compressor (Heat pump) active
7 Operating Operating mode: Optimised operation no time
mode program active.
Operating mode: Program 1 | Program 2
automatic mode active (according to time
program) for displayed heating circuit.
Operating mode: heating mode active.
Operating mode: setback mode active.
Table 2 Symbols in the display
Compress Hybrid 7000i AW – 6721833054 (2020/09)
3.2

Control panel

An overview of the structure of the main menu and the position of the
individual menu items can be found at the end of this document.
An overview of the items that can be found in the info menu is also found
at the end of this document.The info menu is useful to get instant
information of the status of the heat pump.
Each of the following descriptions takes the standard display as its
starting point ( Fig. 3.1.2).
3.2.1

Switching off

The user interface is powered via the BUS interface and is normally
switched on. The system should only be shutdown temporarily,
for example when cleaning filters. The complete system is deactivated
and there is no frost protection during a shutdown.
▶ To temporarily switch off the system:
– Press and hold the selector until a pop-up menu is displayed.
– Select Yes in the menu Switch to standby mode?
▶ To switch on the system:
– Press and hold the selector until a pop-up menu is displayed.
– Select Yes in the menu Switch from standby mode to normal
operation?
After a prolonged power failure or extended period of idleness, the date
and time may need to be reset. All other settings are retained
permanently.
3.2.2

Selecting a heating circuit for the standard display

The standard display only ever shows data for one heating circuit. If 2 or
more heating circuits are installed, a setting can be made to determine
which heating circuit the data in the standard display relates to.
▶ Press the selector and turn to select a heating circuit.
▶ Wait a few seconds or press the selector to confirm.
Operation
6 720 812 775-02.2O
7