Gravely Skidster 200 Owner's/Operator's Manual page 14

Throttle-Diesel Models
SLOW
UNLOCKED
LOCKED
The throttle knob controls the engine speed.
To increase engine speed:
Turn throttle knob to unlocked position.
Pull the throttle knob out slowly until desired
engine speed is reached.
Turn the knob either to left or right to lock in
position.
To decrease engine speed:
Turn throttle knob to unlocked position.
Push the throttle knob in slowly until desired
engine speed is reached.
Turn the knob either to left or right to lock in
position.
Warning Lights-Diesel Models
Oil Pressure Warning Light
If this light comes on, there has been a
loss of engine oil pressure.
OK0560
IMPORTANT: When the oil pressure light comes on,
stop the unit and engine as quickly as possible. Service
or repair unit before restart.
NOTE: The oil pressure light comes on when the key is
turned to RUN or beyond. It should go off once the
engine starts.
Temperature Warning Light
If the coolant temperature reaches or
exceeds a boiling condition the temperature
warning light comes on. If this light comes
OK0280
on, take the following actions:
1. Stop the unit operation in a safe place and run the
engine at idle, without a load.
2. Do not stop the engine. Allow it to idle for 5
minutes.
3. If the engine stalls within that 5 minutes,
immediately leave and stay away from the
machine.
4. Keep away from the unit for at least 10 minutes to
allow the engine pressure to drop.
5. After engine has cooled, check coolant level and
that fan belt is intact.
FAST
LOCKED
OK0421
GB - 14
Hour Meter - Diesel Models
The hour meter records engine operation time. It
operates when the ignition switch is in the RUN
position.
NOTE: For accurate readings, be sure ignition switch is
OFF when unit is not operating.
Traction Control Levers
The traction control levers control the unit's speed and
direction. Always move levers slowly and smoothly.
Refer to Driving the Unit for operating instructions.
CAUTION: STRIKING OBJECTS may
damage unit and result in minor or moderate
injury. Shut off unit and engine. Check for any
damage or loose parts. Repair if necessary
before restart.
Attachment Tilt Lever
To tilt attachment forward, slowly
push the attachment tilt lever
forward.
To tilt attachment rearward, slowly
pull the attachment tilt lever
rearward.
OK0440
Lift Arm Control
WARNING: AVOID BODILY INJURY. Always
return lift arms to down position before getting
off unit or stopping engine.
Move the lift arm lever forward to lower the
lift arms.
Move the lift arm lever toward the rear of
the unit to raise the lift arms.
OK0460