Replacing Ribbon Cartridge - Pyramid 2500 User Manual

Auto Aligning time CloCk inStRuCtionS
model 2500/2650

REPLACING RIBBON CARTRIDGE

For optimum performance, replace ribbon cartridge every 6 months.
C
F
A – Ribbon Cartridge C – Tab
B – Clips
1 Use only genuine Pyramid part number 43079 Replacement Ink Ribbon Cartridge.
Unlock and remove the time clock cover.
2
Prior to removing old ribbon, slide "SETTING" switch to the right. CAUTION: Do not
3
attempt to change the ribbon when in operation mode, as this may result in injury.
To remove old ribbon, pull two clips
4
cartridge, pull straight up using tab
5
Remove new ribbon cartridge from packaging & turn the manual ribbon advance
knob clockwise to straighten ribbon.
E
6 Holding tab
lower the ribbon in front of the ribbon guide
retaining pins
Gently push down cartridge until it snaps into carriage while turning the manual
7
ribbon advance knob clockwise.
8 Turn manual ribbon advance knob clockwise a few rotations to ensure ribbon is
positioned correctly in front of print head.
9 Replace the cover & lock unit.
Feed a time card through unit to test print quality.
10
If time clock prints incomplete characters, the ribbon is not fully installed over print head. If time
clock prints lines that become increasingly light, the cartridge is not fully snapped into the holder.
Reinstall ribbon cartridge, following steps 1-7 until a complete & consistent time card prints.
For assistance, please contact customer support at 888.479.7264.
pyramidtimesystems.com
D – Ribbon Guide F – Retaining Pins
C install ribbon cartridge into print carriage, making certain to
are within clips
F
B
towards you & simultaneously lift ribbon
B
located on top of cartridge.
C
first, then make certain
D
(see diagram).
B
REPLACING RIBBON CARTRIDGE
A
D
E
E - Manual Advance Knob
13